Categories

Bearing and Tool Centre

Adhesion Cross Hatch Tester

₹ 5000.00  Incl. GST ₹ 4237.29 Excl. GST

Description

Simple operation, each Cross Hatch Cutter has 6 cutting blades spaced either 1mm or 2mm apart, one cutting pass makes 6 cuts in the coating, a second pass at 90° makes a square lattice pattern. Apply Adhesive Tape over cut section and within 5 minutes remove tape. Classify the cut area according to the relevant national standard classification guide. The cutting blades are ground onto 6 cutting sides, so that when one cutting side becomes blunt there are a further 5 cutting sides to use. Therefore giving a 1/3 rd extra life over conventional 4 sided models. This Cutter complies with ISO, BS, DIN and ASTM methods of measurement.

The cross hatch cutter will allow an assessment to be made of

 

the adhesion resistance of coatings to separation from substrates

when a right-angled lattice pattern is cut into the coating and

penetrates through to the substrate. Coating is cut into small

squares using cross cuts and reduces lateral bonding, and the

adhesion assessed against ISO, ASTM or customer

specifications. The coating thickness determines the cutter size

used. The 1mm cutter is suitable for coatings under 60 microns;

the 2mm cutter is suitable for coatings over 60 microns. Cross

hatch cutter with 1mm with 11 teeth also available.




Accuracy98%
Packaging TypeBox
Surface FinishPolished
UsageMeasurement
MaterialSS



Minimum Order Quantity: 1
1 Pack contains : 1 Unit
SELLER: Bearing and Tool Centre

Adhesion Cross Hatch Tester

Product code (MPN): ITB-42E411D7
Availability:In Stock
₹ 5000.00  Incl. GST ₹ 4237.29 Excl. GST
  • Description
    Simple operation, each Cross Hatch Cutter has 6 cutting blades spaced either 1mm or 2mm apart, one cutting pass makes 6 cuts in the coating, a second pass at 90° makes a square lattice pattern. Apply Adhesive Tape over cut section and within 5 minutes remove tape. Classify the cut area according to the relevant national standard classification guide. The cutting blades are ground onto 6 cutting sides, so that when one cutting side becomes blunt there are a further 5 cutting sides to use. Therefore giving a 1/3 rd extra life over conventional 4 sided models. This Cutter complies with ISO, BS, DIN and ASTM methods of measurement.

    The cross hatch cutter will allow an assessment to be made of

     

    the adhesion resistance of coatings to separation from substrates

    when a right-angled lattice pattern is cut into the coating and

    penetrates through to the substrate. Coating is cut into small

    squares using cross cuts and reduces lateral bonding, and the

    adhesion assessed against ISO, ASTM or customer

    specifications. The coating thickness determines the cutter size

    used. The 1mm cutter is suitable for coatings under 60 microns;

    the 2mm cutter is suitable for coatings over 60 microns. Cross

    hatch cutter with 1mm with 11 teeth also available.




    Accuracy98%
    Packaging TypeBox
    Surface FinishPolished
    UsageMeasurement
    MaterialSS



    Minimum Order Quantity: 1
    1 Pack contains : 1 Unit
  • FAQs
    Need some help? Ask us!