Description

Specification for panel Size 20: 

1) GET FULL POWER FROM START TO FINISH AT POURING TIME :

Agni electrical provides you a solid state melting unit which melts metal scrap at full power or optimum power as per panel capacity from starting to finishing at pouring time. (Condition: with hot lining).
In this design, you will get full power from start and get more metal for melting in a short time from other designed.

Advantages: Increase foundry productivities and profitability.

2) SECTION OF PANEL PROTECTION:

We are using fast-acting MCCB and ACB with a microprocessor base tripping system. It will help by tripping fast and save power components.
We provide Current Limiting Reactor (CLR) with low DC resistance for protecting while creates any problem from malfunctioning by component.
With low dc resistance, it consumes low power and increase panel efficiency and helps to decrease power consumption in some percentages during panel working condition.

Advantages: Fast tripping saves your costly components with low power loss design.

3) SEPARATELY CARD/MODULES SECTION:

In panel, we provide separate cards and modules section from the power circuit and cooling piping.
Which are totally isolated from high voltage area, this area makes panel descent and clean.

Advantages: for a long life of cards/modules, Totally safety (like in safe zone).

4) SEPARATE PIPING SECTION:

In Panel, we create a separate piping section in this section manifold of input and output of panel sets at the back section of power circuit and components.
Power components save by water leakages in the panel.

Advantages: Easy to operate every path of cooling, Save power components, make your unit cleans.

5) EASY MONITORING MODULE:

Agni electrical gives you a solid state monitor (no relay) for monitoring the panel easily. This is fitted on the front door of the panel with S S Plate.
The monitor module indicates unit problems and limits with the help of Bright LED Bar to alert the operator.

Advantages: Easy to read problems or limits for Unit Operator.

6) PROTECTION CIRCUITS:

In electronic circuits, we are using PS (Potential Sensor) for protecting power components and also electronic circuits.
If panel DC supply short then our new design circuit will not turn on inverter/converter and save your valuable SCRs or other costly power components and also find out which SCR is short with LED indicate in a short time. (New Invention).

Advantages: fast tripping and save power components, easily troubleshooting in a short time at Inverter side.

7) SAFETY ISOLATION:

Line Isolation must require in this design.
Line isolation decreases power consumption and increases the efficiency of the melting unit.

Advantages: Fast melt rates and low power consumption.


Specification for Furnace/crucible Size 20:

1) High strength, rain forced refractory top and bottom connecting with an aluminum castable wall for coil support Available in desk and flush type.

Advantages: Crucible gets a long life with a sturdy design.

2) Proper matching coil fitted in a crucible for getting optimum power continuously of your unit with wooden support with proper utilization of panel power and its efficiency.

Advantages: Proper coil matching with your Induction panel to get optimum power and panel runs at full power continuously.

3) Easy, all-around access and free breather coil simplified the design.

Advantages: Easy maintenances and fast troubleshooting.

4) Rear or Side exit Lead facility available.

5) Hoist tilt is stander; Steering tilting system (in small crucibles) and Hydraulic tilting system are available.