Plate Load Test Apparatus
Minimum Order Quantity: 1
1 Pack contains : 1 Unit
As Per IS 1888 1962, ASTM D 1194, BS 13779
Specification: This is for estimating the bearing capacity of shallow foundations in situ and for the design of flexible pavement. In the test procedure a steel plate is subjected to gradually increasing load and settlements of the plates recorded.
50 tonne hydraulic jack with separate pumping unit fixed to it a 0 - 500KN x 0.5KN. 1No.
Pressure gauge and flexible metal pipe 5 mtr. long 1No.
Special ball and socket arrangement between the jack and the bearing plate 1 No.
Extension rod 12mm dia x 25 cm long for taking dial gauge readings 16 Nos.
Magnetic base with female thread on top for holding extension rod 4 Nos.
Top end plate, 50mm, dia with male thread for fitting onto the extension rods and positioning the dial gauge plunger 4 Nos.
Column 15cm dia x 25cm long with flanges complete with four bolts and nuts 2 Nos.
Column 15cm dia x 50cm long with flanges complete with four bolts and nuts 1 No.
Bridge support of welded steel angle construction, 5 mtr. Span and stands approximately 30 cm. High. Fitted with two quick release clamps a for positioning and holding the dial bracket . 2 Nos.
Plane M.S. 75mm x 25mm thick 1 No.
Plane M.S. plate 60cms x 60cm. Square x 25mm thick. 1 No.
Plane M.S. plate 45cm x 45cm x square x 25mm thick. 1 No.
Plane M.S. plate 30 cms x 30 cms x square x 25mm thick 1 No.
Plane M.S. M.S. plate 75cms x 75cms square x 25mm thick 1 No
